BMW K bikes (Bricks)


You are not connected. Please login or register

K100-forum.com » Technical, repair and troubleshooting » Engine and transmission » Swing Arm Bearings

View previous topic View next topic Go down  Message [Page 1 of 1]

1Back to top Go down   Swing Arm Bearings Empty Swing Arm Bearings Sat May 12, 2012 3:45 pm

Clcinjax

avatar
active member
active member
I pulled my swing arm bearings on my 1985 K100 to inspect and repack. As I understand by reading Clymer there is supposed to be a grease cup/retainer on the inside. This was absent on my bike on both sides. I do not see where a replacement can be ordered. Does anyone know where I can order these or are the actually necessary? Thanks.

    

2Back to top Go down   Swing Arm Bearings Empty Re: Swing Arm Bearings Sat May 12, 2012 3:53 pm

Inge K.

Inge K.
VIP
VIP
Post #1033 in this thread.


__________________________________________________
Inge K.
K100RS -86. (first owner), K1100LTSE -94.
    

3Back to top Go down   Swing Arm Bearings Empty Re: Swing Arm Bearings Sat May 12, 2012 11:40 pm

Clcinjax

avatar
active member
active member
Thank you.

    

4Back to top Go down   Swing Arm Bearings Empty Re: Swing Arm Bearings Sun May 13, 2012 2:17 pm

sidecar paul

sidecar paul
Life time member
Life time member
I have a late swing arm (black) and that has no grease retainers, so did BMW stop fitting them at some stage?

Paul.


__________________________________________________
'84 K100RS (0014643) (owned since '85), 86 K100RS (0018891) with Martello sidecar (built as an outfit in '88),
'51 Vincent (since '67),'72 Montesa Cota (from new), '87 Honda RS125R NF4 (bought 2015) 
....No CARS never ever!
    

Sponsored content


    

View previous topic View next topic Back to top  Message [Page 1 of 1]

K100-forum.com » Technical, repair and troubleshooting » Engine and transmission » Swing Arm Bearings

Permissions in this forum:
You cannot reply to topics in this forum