1 Rebuilding K75 electrics woes. Wed Aug 22, 2018 6:05 pm
edmundf
Silver member
So,
Trying to rebuild the electrics on this K75, getting precisely nowhere so any thoughts would be appreciated -
I got the bike as far as the starter turning over. I then went to reinstall the radiator / pipes etc. Once that was done i turned on the bike again and noted that the gear selector was not working nor the neutral light or the oil light. Basically the right hand side of the instrument cluster was dead. This also included the starter. I did find a relay fused open (load shed) which i replaced. So far i have checked
- all the fuses
- all the connections at the back of the console
- every damn relay
- stripped and rebuilt the right hand handlebar switch-gear
- clutch switch
The switches on the right hand side are working - turn signal (including the green indicator on the RHS of the cluster) turn cancel, light switch. I checked the starter relay and i am not getting any voltage at the input pins. i am hesitant to short the relay to see if i can get the starter to turn.
I am hoping that someone might have an idea where to start trouble shooting - i got as far as pulling the plug from the electronic ignition module (i am trying to following the guide here http://www.kforum-tech.com/electrical/EFI/bike-wont-start-EN.htm) and could not see any voltage at pin 6 or 11.
Any thoughts on where might be the next best place to continue troubleshooting?
cheers
Ed
Trying to rebuild the electrics on this K75, getting precisely nowhere so any thoughts would be appreciated -
I got the bike as far as the starter turning over. I then went to reinstall the radiator / pipes etc. Once that was done i turned on the bike again and noted that the gear selector was not working nor the neutral light or the oil light. Basically the right hand side of the instrument cluster was dead. This also included the starter. I did find a relay fused open (load shed) which i replaced. So far i have checked
- all the fuses
- all the connections at the back of the console
- every damn relay
- stripped and rebuilt the right hand handlebar switch-gear
- clutch switch
The switches on the right hand side are working - turn signal (including the green indicator on the RHS of the cluster) turn cancel, light switch. I checked the starter relay and i am not getting any voltage at the input pins. i am hesitant to short the relay to see if i can get the starter to turn.
I am hoping that someone might have an idea where to start trouble shooting - i got as far as pulling the plug from the electronic ignition module (i am trying to following the guide here http://www.kforum-tech.com/electrical/EFI/bike-wont-start-EN.htm) and could not see any voltage at pin 6 or 11.
Any thoughts on where might be the next best place to continue troubleshooting?
cheers
Ed