Took out key from ignition and put back in....could not turn to second click???(on position)

fishboy316

fishboy316

Life time member

Number of posts : 477

So I took the key out of the ignition and when put back in could'nt get it to go to the second "click". Took 15 minutes to get it to the run position. Shocked

Any ideas?
Thanks
Bill

moriarti

moriarti

Life time member

Number of posts : 700

Hi Bill sounds like the pin is jamming, you can try WD40,or PULL CYLINDER out and do a full cleanup,Good luck with it Very Happy

fishboy316

fishboy316

Life time member

Number of posts : 477

Thanks for the reply. I will give it a go!

Bill

Laitch

Laitch

Life time member

Number of posts : 3252

Ignition switch cleaning instructions. It's likely the entire mechanism in yours will need it eventually anyway.

fishboy316

fishboy316

Life time member

Number of posts : 477

Thanks for the help. I did get it going with a few squirts of Electronics cleaner and some spray electronics lube.
Looking at the Helpful Instructions for cleaning the switch I thinkI will do a full clean soon.

Thanks again for the help
Bill

Sponsored content

1 Took out key from ignition and put back in....could not turn to second click???(on position) Thu Apr 14, 2022 8:58 am

fishboy316

2 Re: Took out key from ignition and put back in....could not turn to second click???(on position) Thu Apr 14, 2022 10:14 am

moriarti

3 Re: Took out key from ignition and put back in....could not turn to second click???(on position) Thu Apr 14, 2022 11:09 am

fishboy316

4 Re: Took out key from ignition and put back in....could not turn to second click???(on position) Thu Apr 14, 2022 9:47 pm

Laitch

5 Re: Took out key from ignition and put back in....could not turn to second click???(on position) Mon Apr 18, 2022 8:57 am

fishboy316

6 Re: Took out key from ignition and put back in....could not turn to second click???(on position)

Sponsored content