Guys, I've removed the centre stand permanently, just looking at putting the side stand back on after a custom build but it retracts back and hits the rear wheel, what should it stop up against? I presume it was the original exhaust (which I am not using)?

So, what are my options, I'm guessing this has been done a fair few times before so hoping someone will know or be able to give me a little advice....

Thank you!!

Paul

The OEM exhaust has a rubber block that the stand rests against when retracted.
Regards Martin.

Cheers Martin.....thinking I may weld something up by the side stand bushing.....hmmmm!

Now would be a good time to posts some photos of your project or maybe post them in a thread dedicated to your project in the renovation/customization section.