1 Blinkers wont blink , is my blinker unit toast? pictures inside , K75 1989 Sat Nov 12, 2016 2:18 pm
Letomoto
active member
Hello im having troubles with the signals on a K75 , i got 12v at the blinker module from the two fuses , got ground , also receiving grounds from my switches at the module and i been able to make both side blinkers light up by manually actuating the relays in the green box module.
Theres a resistor thats getting waaaay hot i actually burnt my finger on it , the module was getting warm. Also wondering if the capacitors are usually covered by any kind of resin or they actually overheated and leaked on the board .... could it be due to something else in the wiring of the bike or its a common failure ?
Would like to understand the problem before ordering a unit
Thanks
Theres a resistor thats getting waaaay hot i actually burnt my finger on it , the module was getting warm. Also wondering if the capacitors are usually covered by any kind of resin or they actually overheated and leaked on the board .... could it be due to something else in the wiring of the bike or its a common failure ?
Would like to understand the problem before ordering a unit
Thanks