OK,  I have 3-small rubber washers and 2-Large rubber washers with a groove all the way around them, I then have a metal bushing (its not the one for the brake lever ) I have no idea where these go, any ideas

Nice fabric! What is that pattern?

Thanks for the compliments on the bed spread :king:

The length of the bushing is 25mm, Outside Diameter is 14mm, Inside Diameter is 8.40mm

The Large Rubber Outside Diameter is about 26.5mm the inside diameter is 10.14mm and 5.45mm thick

The small Rubber Outside diameter is  16.9mm the inside diameter is 6.3mm and 2.80mm thick

Rear ducktail fairing mount , sandwiches the fiberglass where it bolts to the frame, inside where the tool box lives under the seat.

Bushy.

Do you mean this?

Large Gromet #11 on the seat hinge bracket


Small gromet #3

the steel bushing could be from a rubbermounting for  a foot peg plate


k-rider

Further to what Bushy mentioned, the two larger "rubbers" are in the ducktail at the rear.  They are located just in front of the rear brake light and are sandwiched in between the bracket which holds the rear wheel mudguard in place (from underneath).  Should have a penny washer on top and a 10mm lock nut will hold it all together.  The rubber is more of a vibration damper. 

It is also necessary to loosen these two nuts if you wish to remove the rear plastic registration plate fitted below the rear brake light.  There are also two self tapping screws here holding it up snug.  Might want to check they are firm.

Hope this helps.

Dave.

#13.

k-rider wrote:the steel bushing could be from a rubbermounting for  a foot peg plate

Could also be the silencer mount.

Thanks Inge.

Inge K. wrote:

k-rider wrote:the steel bushing could be from a rubbermounting for  a foot peg plate

Could also be the silencer mount.

Inge K., BINGO bushing goes in the silencer mount!

I also assume this is what 11 and 12 would be on the parts diagram?

Looks right to me!

Thanks Inge +1 from me.