1 Output shaft seal instalation Sat Mar 13, 2010 12:40 pm
japuentes
Life time member
Hi there.
Regarding the subject, manual (Haynes) indicates to set the seal flush with the housing, but service bulletin 2798 indicates to let it projecting 0.5mm out in order to ensure a perfect seal.
I´ll appreciate your opinion on this issue.
Best regards
JAP
Regarding the subject, manual (Haynes) indicates to set the seal flush with the housing, but service bulletin 2798 indicates to let it projecting 0.5mm out in order to ensure a perfect seal.
I´ll appreciate your opinion on this issue.
Best regards
JAP