1 Front master cylinder rebuild...still leaking! Mon Feb 01, 2010 8:23 am
blaKey
Life time member
</A></A></A>Well, my front master cylinder was leaking so I pulled it apart. The bore was too scored so I bought a resleeved cylinder and installed a new piston assembly.
Mmmm...two bits left over: metal washer and a round donut-shaped thingo (see arrows)
The photo below shows arrows pointing to my leftover bits...
Below is a photo of a brand new master cylinder that shows my leftover bits:
But when I first took off the master cylinder, those bits were not there. I can only assume that
the previous owner left them out?
Can you please tell me where they are suppose to fit?
Mmmm...two bits left over: metal washer and a round donut-shaped thingo (see arrows)
The photo below shows arrows pointing to my leftover bits...
Below is a photo of a brand new master cylinder that shows my leftover bits:
But when I first took off the master cylinder, those bits were not there. I can only assume that
the previous owner left them out?
Can you please tell me where they are suppose to fit?
Last edited by blakey on Mon Feb 01, 2010 8:24 am; edited 1 time in total (Reason for editing : Amending text.)
__________________________________________________
Neil
K100RS 1986 RED!
Dress for the ride and the potential slide.