Hello I'm doing a new loom for my k100rs and I was wondering if anyone could give me some information on the type of wire to be using. So far I'm doing the tail light, FICU (brain box under the seat) some wires have been cut.

Now as I lost the whole rear end I've lost that part of the wiring and can't really see how it all goes I work best on images than diagrams so if anyone has any pictures it would be a great help.

http://www.vehicle-wiring-products.eu/section.php/198/1/single-core-pvc-thin-wall-cable

16/0.2 and 32/0.2. It's a shame you can't get tracers in 16/0.2 because 11amp wiring is adequate for most jobs. If you can wait a day or two, my next section to-do on Brick2 is the ar$e. This thread here, if you haven't been following it:

https://www.k100-forum.com/t10428-comberjohn-s-ghost#123405

Dai wrote:http://www.vehicle-wiring-products.eu/section.php/198/1/single-core-pvc-thin-wall-cable

16/0.2 and 32/0.2. It's a shame you can't get tracers in 16/0.2 because 11amp wiring is adequate for most jobs. If you can wait a day or two, my next section to-do on Brick2 is the ar$e. This thread here, if you haven't been following it:

https://www.k100-forum.com/t10428-comberjohn-s-ghost#123405

Thank you for the link this will be my first time at reproducing the wiring (any wiring) so a little bit anxious and nervous about starting it. However after finding the wires cut in the brain box and the whole tail piece had gone I've got to learn somewhere.

Unfortunately I haven't been on that much recently. I've mainly been using the k75/k100 facebook owners group. Just because it was easier to post saves created a load of threads for some silly questions. Haven't even really updated the thread on here either although that was in the wrong section.

So that means I haven't really been looking into many threads. I don't mind waiting I've still yet to get the seat sorted out on the Frankensmiler (Bibo's new name). Here is an updated image of both of my bikes below; bad quality image I'm sorry.




EDIT:

There is a lot of different wiring diagram on the download page.
In fact, yesterday I added the ones from Comberjhon post.
The page with the wiring brake down could be some help too: http://hrsbstaff.ednet.ns.ca/bvogel/K100/download/electrical/diagrams/interactive_diagrams.htm

CF

Thank you crazy frog I'll be using them thoroughly, I've just been going over the bike and taken some images just to give you a feeling of the wiring I've got to cope with.

Obviously you can see how bad the thieves have been, also there is another image below it's of the indicator wiring with mystery wiring to go with it, no idea what these are.

Green/black and brown wires are the heated grip feed. I'm assuming it's green/black but the tracer is not visible in the picture.