BMW K bikes (Bricks)


You are not connected. Please login or register

View previous topic View next topic Go down  Message [Page 1 of 1]


1Back to top Go down   Can I Cut These Wires Off.... Empty Can I Cut These Wires Off.... Mon Apr 06, 2015 2:21 pm

bettyswolloks

bettyswolloks
active member
active member
Hey all, quick question.

I'm in the process of moving the ignition switch and getting rid of the pad that covers the bar clamps, can I cut off the wires that are on the rubber pad with the ignition switch? I have 4 switch's on the pad, none work, 2 or already disconnected, so am I ok to get rid of the rest?

http://ranfog.co.uk
    

2Back to top Go down   Can I Cut These Wires Off.... Empty Re: Can I Cut These Wires Off.... Mon Apr 06, 2015 5:30 pm

Ringfad

Ringfad
Life time member
Life time member
It is probably best to follow the wires back and remove them complete with the plugs.

My last bike was like this - bare wires sticking out of the switch holes.

I have since re-soldered them to switches and they now all work (ABS switch and Hazard lights in my case).


__________________________________________________
Can I Cut These Wires Off.... Ir-log10

 ;BMW; K1 Black 1993 60K Km     ;BMW;  K1100RS Black 1996       ;BMW; K1 Blue 1990 25K Miles

 ;BMW; K1200RS Red
    

3Back to top Go down   Can I Cut These Wires Off.... Empty Re: Can I Cut These Wires Off.... Mon Apr 06, 2015 10:00 pm

Holister

Holister
Life time member
Life time member
+1 that. Remove anything not used but I would have to assume you've got wiring for the hazzard lights there which should be connected.

My bike's PO had a bunch of redundant wiring wrapped in and around the head, some of it leading back to the electrical box which was unswitched power that wasn't teminated. Plus the grip heaters were wired directly to power (unswitched) also. I found I had a small power drain which nearly crippled my battery had I not found it in time.

This is what I pulled out Shocked
Can I Cut These Wires Off.... Redund10


__________________________________________________

1989 K100RT     VIN  0097367 (naked)  
1996 K1100RS   VIN  0451808
 Can I Cut These Wires Off.... Austra12    Fuel:  95 Octane
Engine Oil: Nulon Full Synthetic 15W50
Gear Box Oil:  Nulon Synthetic 75W90
    

4Back to top Go down   Can I Cut These Wires Off.... Empty Re: Can I Cut These Wires Off.... Tue Apr 07, 2015 6:59 pm

88

88
Life time member
Life time member
"Can I cut these wires off?" - they're your wires, y'can if you wan't but better to take the others advice and unplug. If you do cut leave a tail at the switch so it can be re-soldered. Some bugger cut the Hazard loom on my bike right at the switch there isn't enough to solder back to.


__________________________________________________
Can I Cut These Wires Off.... Ir-log1188....May contain nuts!Can I Cut These Wires Off.... Ir-log11

"The world is a book and those who do not travel read only one page." - St. Augustine from 1600 years ago & still true!

K1 - 1989 - AKA Titan (unique K1/K1100RS hybrid by Andreas Esterhammer)
K1100RS - 1995. AKA Rudolf Von Schmurf (in a million bits)
K100RS - 1991 AKA Ronnie. Cafe racer project bike
K75RTP - 1994
K75C - 1991 AKA Jim Beam. In boxes. 
K1100LT 1992 - AKA Big Red (gone)
K100LT - 1988 - AKA the Bullion brick. Should never have sold it.
    

5Back to top Go down   Can I Cut These Wires Off.... Empty Re: Can I Cut These Wires Off.... Wed Apr 08, 2015 3:48 am

bettyswolloks

bettyswolloks
active member
active member
Thanx all, I figured I could just get rid of them as the bike ran and none of the switches worked, just wanted to make sure before removing them.

http://ranfog.co.uk
    

6Back to top Go down   Can I Cut These Wires Off.... Empty Re: Can I Cut These Wires Off.... Sat Apr 25, 2015 5:09 am

bettyswolloks

bettyswolloks
active member
active member
They got cut and sealed. Couldn't follow them back that far as to get to a block, with time I imagine I could of done but they got snipped back just to see if all was well when they were redundant, any way. To answer my own question, yes, yes you can.

http://ranfog.co.uk
    

Sponsored content


    

View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum