Hi guys , I need help with a couple of measurements re. the rear ducktail piece.
  
  I am making up my own carrier/ topbox mount and would like to know the dimensions 

  of the mounting bolt pattern. I have drilled the upper frontmost holes with an angle

  drill through the strengthened bosses but have to drill the rearmost two from the outside

  and would like to get as close as possible to those bosses. I measure 168 mm centres for 

  the front 2, so need dist between the rear 2 and front to back dist each side.

   Hope that's clear, thanks, G

158mm between the rears and 136mm front to back.

good luck gordo

have to do similar soon ....pics please !!!

By my reckoning that took just less than one and a half hours for an answer to my problem!

  Thanks Bikerboy.

  This forum is FANTASTIC. 

  Crazy Frog , you have a Gold pass to the Pearly Gate!

  A pic.


This is BERT.

 Friends of mine have an animal sanctuary and care for injured/orphaned creatures.

This is BERT, A baby TawneyFROGmouth.

Thanks to Bikerboy I got the mounting holes drilled then set about carving a piece of 4mm aluminium plate.

Boy I miss the fully equipped engineering workshop 60 metres from my home in Tassie!


Various slots for bungees or straps. Tri oval cutout for the roundel is an attempt to mimic the exhaust end shape.


  Kick up at the rear so swag is located prior to strapping on. This will become the base for an expandable top bag when the swag is not required.

Cheers, Ghost

nice job gordo