Here's the light control (Right side) on the back we will remove the piece that holds the wires, removing the screw marked with arrow



Removing this screw allows us to pull the turn signal switch to remove



Now let's remove the screw holding the button turn signal cancellation. You have to pay special attention, because in this hole there's the light switch screw marked with the black arrow, note that the cancellation is in a vertical plane while the light is in a horizontal plane.



This is the position of the screwdriver to remove the screw-flash cancel button



When you start to loosen the screw, you must be careful to hold the button, so do not jump the ground and slip



In the button you can see the pier and slip switch





And what is your position.



Now you can see the screw on the remote control of lights, as I said this is in a horizontal plane.





Never remove the screw holding the plastic before.





Carefully remove the slide it is below the pier and the steel ball.



The steel ball is often left in the hole, look carefully.



When you remove these screws has been very careful with contact steel ball and spring brass





Now carefully lift the white slide



You can see the spring contact and the ball





Your turn to clean



Dismantle the emergency stop



With a small screwdriver you a little leverage



Remember holding work when removing red cables, since the part which is also very sensitive





Do not miss these two springs





As the cable sheath is too damaged, you can put some heat shrink, we need to remove the connector



With a small screwdriver do a bit of pressure to bend a small tabs that keep out the contact back. Look at the following two photos



By pressing the tabs have collapsed, allowing passage through the plastic connector



Now we have to open the tabs, so that when we insert the contacts into the connector, are set



With a little patience is out the connector.



This is the reason for removing the connector





Apply heat





Cleaning and lubrication



That's how the contacts were dirty



I had a problem with the intermittent contact



We pulled the pin


The dirt was widespread, clean and assemble



More cleaning



We cleaned



Clean and lubricated (Vaseline)



Clean and grease







This part is very delicate, the contact is easily damaged, and if you lose your way will cost you to make it work well so arming you patience.



All clean and ready for lubricating oil on



Already lubricated and cleaned contact



You must be very careful when mounting the slide with the contact and spring, spring ball and the ball, holding the whole loosely and put the screw.



The ball is under the dock



We present the slide while holding the whole



And finally look with screw



EThis is the smallest screw, if you put another in his place, you can remove the front and not look good.



We will mount the flash cancel button, you can now take advantage of and clean up a little, well, you can carefully review the outline of the symbol, with a permanent marker.



Clean and lubricated



Hold it while you put the screw



Remember that in this there is the sliding screw the lights but on another level.



And finally put in place the right turn signal button and screwed.





this. this, this is all folks.

Regards

Excellent, informative post - Thanks.

Mike

Thank you , this is a valuable and informative piece. It will find its way into the collection of knowledge i am certain, very good photography also, please keep it coming.

nice job

use a dremel with a small brush (brass) to renew the plastic buttons