Does anyone have a part number for an aftermarket fuel filter?

I can find one with 3/8 (10mm) male ends, rated at 100psi (stainless)- but no 5/16 (8mm) (Jeggs filter)

Napa filters are Wix filters under the NAPA name.
I tried Wixfilter.com but couldn't get anywhere.

Cheers, M

Look a bit further in the posts. I have seen it here.

Albyalbatross1 wrote:Look a bit further in the posts. I have seen it here.

I can see two threads - but perhaps I'm looking in the wrong place - I used 'FILTER' in the search engine.
I can see online a USA NAPA part #3032 - 5/16 male ends - inline fuel filter with a 60lb burst rate.
We run at 32psi don't we - unless the pressure reg goes out then it goes up to 60 - but we've got more problems than fuel filter splitting at that time don't we?

The Jags filter is rated for 100 PSI with a stainless body but 3/8 male ends and 5 1/2 inches long overall, for $17.
http://www.jegs.com/i/JEGS-Performance-Products/555/15175/10002/-1?parentProductId=759981


Are the 10mm (3/8 barbs) an issue??

Cheers, M

valid for K75-K1100

to google:

Mahle KL 145

Mann+Hummel MWK 44

everything else is junk

zonenfeile wrote:
everything else is junk

lol

To be added to the non junk list: Knecht KL 145.

Inge K.

Inge K. wrote:To be added to the non junk list: Knecht KL 145.

Inge K.

Apparently, that filter is difficult to get in the USA.
I see mention of a Deutsch filter # ff424 - which again is hard to get - Fram have a plastic equivalent, but I cannot see any pressure rating.
Wix filters cross references this Deutsch filter with their filter #33032 which is the NAPA 3032 filter posted earlier in this thread. Rated 60 PSI burst and 20 micron filter.

I'll keep looking...
Cheers, M