1 Another 'My bike won't start'. Sun Mar 06, 2011 12:54 pm
Comberjohn
Life time member
Hoping this won't tax too many grey cells.
Yesterday I went to my daughter's to bring my '89 K100LT home to my new workshop for a few jobs. Hadn't been run for about 2 months but started without any problems!
When starting to move off it did take a few seconds to get it going again but put that down to being well down reserve and seeing I was only going a couple of miles, I restarted and drove on.
Got home ok and decided to give it a wash before starting my few jobs. After I washed it, it wouldn't run on all four and eventually cut out. Put a gallon of fresh fuel in but now it won't run at all.
Pulled the plugs but no smell of fuel on them. Gave them a clean and they seem to getting a spark ok.
When I put the fresh fuel in after washing it the usual small amount of water fell into the tank and now I'm wondering if the water has built up in the tank and letting it run so low has allowed the pump to suck it up and blocked the pump/filter/injectors.
Is there a way to prevent this water getting into the tank after washing it?
What is the best way to purge any water from the system?
Yesterday I went to my daughter's to bring my '89 K100LT home to my new workshop for a few jobs. Hadn't been run for about 2 months but started without any problems!
When starting to move off it did take a few seconds to get it going again but put that down to being well down reserve and seeing I was only going a couple of miles, I restarted and drove on.
Got home ok and decided to give it a wash before starting my few jobs. After I washed it, it wouldn't run on all four and eventually cut out. Put a gallon of fresh fuel in but now it won't run at all.
Pulled the plugs but no smell of fuel on them. Gave them a clean and they seem to getting a spark ok.
When I put the fresh fuel in after washing it the usual small amount of water fell into the tank and now I'm wondering if the water has built up in the tank and letting it run so low has allowed the pump to suck it up and blocked the pump/filter/injectors.
Is there a way to prevent this water getting into the tank after washing it?
What is the best way to purge any water from the system?