1 Warning lamp barely lighted Wed Sep 26, 2018 9:30 pm
Yeyo53
active member
Hi there, fellas.
I recently bought a Acewell MA085 + BEP 3.0 and after the installation I have this problem. When I turn on my key all the lights come up as it should be but when I ignite the bike the warning lamp keeps barely lighted.
I removed all wires from the bep (except current, ground and warning lamp) and the problem persists. It's like some residual current keep there. Do you have any ideas? I bought it in cafe4racer and I don't know if it is an acewell problem (to ask for warranty) or a BEP 3.0 or an installation issue.
I have only tested the bike in the stand and in idle (~1000rpm) so my first though was about the alternator not working at those RPMs but if I accelerate nothing change, and in the case it was for example the alternator it should go completly off if I remove the ALT wire from the BEP, right?
Thanks in advance!
I recently bought a Acewell MA085 + BEP 3.0 and after the installation I have this problem. When I turn on my key all the lights come up as it should be but when I ignite the bike the warning lamp keeps barely lighted.
I removed all wires from the bep (except current, ground and warning lamp) and the problem persists. It's like some residual current keep there. Do you have any ideas? I bought it in cafe4racer and I don't know if it is an acewell problem (to ask for warranty) or a BEP 3.0 or an installation issue.
I have only tested the bike in the stand and in idle (~1000rpm) so my first though was about the alternator not working at those RPMs but if I accelerate nothing change, and in the case it was for example the alternator it should go completly off if I remove the ALT wire from the BEP, right?
Thanks in advance!