1
Clock jumps Tue Jul 24, 2018 3:27 pm
nobbylon
Silver member
Set my clock a few times now but it jumps to a random time! any ideas folks? thx
Message [Page 1 of 1]
1
Silver member
2 Re: Clock jumps Tue Jul 24, 2018 5:59 pm
MartinW
Life time member
Either you are going so fast that you are warping time. Or a bad connection or dry solder joint. 
Regards Martin.
Regards Martin.
3 Re: Clock jumps Tue Jul 24, 2018 6:21 pm
sidecar paul
Life time member
nobbylon,
You could try this idea that I used to increase the pressure on the contact strips of the liquid crystal display.....it might work!
https://www.k100-forum.com/t4319-clock-repair
Paul.
You could try this idea that I used to increase the pressure on the contact strips of the liquid crystal display.....it might work!
https://www.k100-forum.com/t4319-clock-repair
Paul.
4 Re: Clock jumps Tue Jul 24, 2018 6:43 pm
robmack
Life time member
Poor connection with Pin 1 on the OEM connector. Might also be a poor connection with the flexible circuit card strip inside the gauge cluster but tackle the Pin 1 problem first.
5 Re: Clock jumps Tue Jul 24, 2018 6:46 pm
nobbylon
Silver member
thanks for the suggestions. Another job to do!
Message [Page 1 of 1]
Similar topics
Permissions in this forum:
You cannot reply to topics in this forum
