Ignition Switch Removal and Replace with Maintained Switch

jmccrary

jmccrary

Silver member

Number of posts : 59

I did some searching and did not see anywhere. I want to remove the ignition switch and replace with a maintained single-pole, single-throw switch. I was reading the wiring diagram and just wanted to double check something. I have never hot-wired a vehicle, but it appears that the I will need two switches.

Switch One - Red/Green wire
Switch Two - Green-Blue/Grey

Then to start the bike, both of those switches will need to be flipped "on".

Can someone please confirm my theory? I did some searching, but could not find anything in this area. TIA!

Laitch

Laitch

Life time member

Number of posts : 3261

Why would Switch 2 be needed to start the bike?

BobT

BobT

Life time member

Number of posts : 596

Switch 2 would only be needed to allow the parking lights to be switched on when the engine is not running.

robmack

robmack

Life time member

Number of posts : 2334

- Power to start the bike is provided by the switch contacts for Red - Green wire pairs
- Power to run everything connected to Fuse #2 is provided by the switch contacts for Grey/Blue - Grey wire pairs

You could achieve this equivalent function by using a DPDT switch - centre off switch.
- centre position = ignition off
- switch left = park position
- switch right = on position

Ignition Switch Removal and Replace with Maintained Switch Ftlnyg

Ignition Switch Removal and Replace with Maintained Switch Ftlnyg

92KK 84WW Olaf

92KK 84WW Olaf

Life time member

Number of posts : 7963

I did that a number of years ago with my Honda CB500-4 when the ignition failed.

I quickly learned it was wise to have a second master switch on the power supply tot he ignition side and well out of the way......back then curiosity in these bikes was high and it saw people fiddling with it..ignition left on leading to flat battery.

Dai

Dai

Life time member

Number of posts : 5715

OTOH, I have to ask - who leaves their parking lights on these days? In the UK, it's no longer a legal requirement to even have them. I'd buy an ignition switch from ebay (almost any one will do) and just connect the red across green in the 'on' position, then make a permanent connection slate to slate/blue.

jmccrary

jmccrary

Silver member

Number of posts : 59

Thanks gents! All makes sense. I was not sure if the green-blue/grey was needed once the bike was started. I was thinking of a DPST switch or relay if not we’re needed, but those are not that easy to find lol.

Sponsored content

1 Ignition Switch Removal and Replace with Maintained Switch Tue Apr 03, 2018 10:36 pm

jmccrary

2 Re: Ignition Switch Removal and Replace with Maintained Switch Wed Apr 04, 2018 12:07 am

Laitch

3 Re: Ignition Switch Removal and Replace with Maintained Switch Wed Apr 04, 2018 5:42 am

BobT

4 Re: Ignition Switch Removal and Replace with Maintained Switch Wed Apr 04, 2018 8:16 am

robmack

5 Re: Ignition Switch Removal and Replace with Maintained Switch Wed Apr 04, 2018 10:27 am

92KK 84WW Olaf

6 Re: Ignition Switch Removal and Replace with Maintained Switch Wed Apr 04, 2018 4:10 pm

Dai

7 Re: Ignition Switch Removal and Replace with Maintained Switch Wed Apr 04, 2018 6:11 pm

jmccrary

8 Re: Ignition Switch Removal and Replace with Maintained Switch

Sponsored content