1
Aftermarket speedo Wed Jun 08, 2016 12:48 am
Phil63
active member
Hi guys,
I am doing a cafe racer conversion to my '84 K100, I am getting rid of the old motometer, have put in a gps speedo and am now putting some idiot lights in, all is going well but a couple of questions;
I want a neutral light, is there an easy way to do this as it looks like all the wiring is involved in the gear selector readout.
I have an electrical diagram, for the push button starter (the button has popped off my original) can I simply connect the two wires to my aftermarket momentary switch.
Not worried about the pull in the clutch starter complication
I am having probs getting my tail light to work, brakes are no prob but appears tail light wire is dead, to bypass a possible dead wire in the harness can I run a wire from my head light to my tail light and how would I do this to cater for both high and low beam?
Thanks for any help, I have searched through the forum but ended up a little more confused, obviously not a sparky.
I am doing a cafe racer conversion to my '84 K100, I am getting rid of the old motometer, have put in a gps speedo and am now putting some idiot lights in, all is going well but a couple of questions;
I want a neutral light, is there an easy way to do this as it looks like all the wiring is involved in the gear selector readout.
I have an electrical diagram, for the push button starter (the button has popped off my original) can I simply connect the two wires to my aftermarket momentary switch.
Not worried about the pull in the clutch starter complication
I am having probs getting my tail light to work, brakes are no prob but appears tail light wire is dead, to bypass a possible dead wire in the harness can I run a wire from my head light to my tail light and how would I do this to cater for both high and low beam?
Thanks for any help, I have searched through the forum but ended up a little more confused, obviously not a sparky.
