1 Gluing a bearing in place Thu Mar 10, 2016 10:08 pm
Kyle10
Life time member
I am about to glue a bearing race in place in order to prevent it from spinning. What is the best way to prep the metal for the epoxy? From what I've read I am not only supposed to clean it but abrade it slightly. I'm not too keen on doing this unless it's absolutely necessary.
I'm using Loctite 272.
Gluing the output shaft bearing in place, as per recommended.
I'm using Loctite 272.
Gluing the output shaft bearing in place, as per recommended.
__________________________________________________
1985 K100rt 0052183
1983 Honda VF750 007713